Front drive shaft
Afternoon all....now that the turkey keg has shrunk sufficiently for me to squeeze below a "G", faced with a problem....What way round does the front shaft go?
Been such a long time from removing it...can't remember!!
Sliding segment to front or to Xfer case?
Any help gratefully received.
without venturing out into the cold im 99% sure the slip yoke goes to the tc, hope this helps
EPC data sheets show fron prop shaft with sliding joint at the axle end and rear prop shaft with sliding joint at transfer case end.
Just went outside and checked under mine and that's the way mine is set up (and it works OK)
Good luck,
:shock:
Ive all ways put them on backwards so!! :oops:
just presumed it would be better to keep slip yoke as far away from the slop as possible
as they say, presumption is the mother of all fuck ups!!
JOIN THE GWOA
This website and forum are provided for the benefit of enthusiasts and owners of all Mercedes Benz off road vehicles, in particular the G Wagen. The costs of development, upkeep and provision of the site are met entirely by the annual subscriptions of club members. If you are using the site and are not a member of the G Wagen Owners Association please consider joining. You will have access to areas on the site that are not open to non members, to club trips and meetings and to technical assistance. In addition your contribution (only £25 annually) will help us maintain and develop our website for future users.
Who's new
- Jaffa_JIM_23
- Wrabstar
- GG
- KTMSCANIA22
- 280ge
Hi Mick, Splatt braved the cold...+ I'm afraid your 1% was right...not the 99%!!