Clutch fitting problem!
Sun, 27/06/2010 - 18:13
hi i decided to take on replacing the clutch in my 1985 300GD my self, i am now regretting it,
i have the Russek manual which i find pretty vague,
my problem is i cant figure out how to take out the starter motor bolts? is there some trick to this?
i have the drive shaft disconnected, the gear box supported , the slave cylinder disconnected etc
any comments /tricks about getting old clutch out and fitting new appreciated,
Lloyd
Sun, 27/06/2010 - 19:24
#1
Re: Clutch fitting problem!
Very long ratchet extensions and x-ray vision (or very sensitive hands and fingers). You cannot see many of the nuts/bolts you need to get at, top of starter and top of gearbox.
Good diagrams and a second person holding a good light help (a little).
thanks again just wanted to check if i was missing something obvious